油研流量比例閥,BG-03-32
3。開始時的注意事項
在初始操作或長休息后,上面的操作中,泵可吸流體的困難。
在這種情況下,排氣閥應該事先安裝的排出側(型號為ST1004 - * -10
*目錄序號酒吧。 EC - 3001 ),或略有放緩的排出側連接的排氣。
起動時,間歇性地操作泵,盡可能與無負載。
對于流體粘度啟動,請參閱上述“液壓油”的項目。
Set the suction pressure within -20 to +30 kPa (5.9 in. Hg vacuum to +4.3 PSIG) at the pump inlet.
In addition, use suction pipes having the sizes shown in the dimensional drawings. If the pump is installed above
the tank level, set the suction port more than 1.0 m (3.3 ft.) below from the oil level.
3. Precautions at Starting
At an initial operation or at an operation after a long rest, the pump may have difficulty in sucking up the fluid.
In such cases, an air bleed valve should be installed beforehand on the discharge side (model No. ST1004-*-10
油研流量比例閥,BG-03-32
021-39526589
網址:m.medieval.com.cn
地 址:上海市嘉定區嘉涌路99弄
6號樓713室